Lynx-studio Hilo Reference A/D D/A Converter System - Owner� Instrukcja Użytkownika Pobierz pdf (Strona 58)

Page 54

The wiring method for unbalanced connections with XLR connectors to RCA/Phono phone connectors using shielded

twisted pair cable (2 wire + shield) is as follows:

XLR Pin 1 (GND) to cable shield with no connection on the other end

XLR Pin 2 (+) to signal wire and to the Phono center pin

XLR Pin 3 (-) to the other signal wire and to the Phono sleeve

XLR Male

or Female

2 Conductor shielded cable

RCA/Phono Plug

(Unbalanced)

5.3.3 Unbalanced Connections with Single Conductor Cable

In some cases it may be necessary to use single-conductor cable to adapt to unbalanced devices. These cables are

considerably more susceptible to interference and grounding problems than the two conductor cables shown above.

Two-conductor cables should be used whenever possible.

The wiring method for unbalanced connections with XLR connectors to unbalanced ¼” phone connectors (tip and

sleeve only) using coaxial cable (1 wire + shield) is as follows:

XLR Pin 1 (GND) no connection

XLR Pin 2 (+) to signal wire and to the ¼” phone tip

XLR Pin 3 (-) to the cable shield and to the ¼” phone sleeve

XLR Male

or Female

2 Conductor shielded cable

TipSleeve

1/4" Phone Plug

(Unbalanced)

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Brak uwag

Lynx-studio Hilo Reference A/D D/A Converter System - Owner� Instrukcja Użytkownika Strona 58